Q.01

How do I find US pesticide tolerances for a crop?

US pesticide tolerances are set by EPA in 40 CFR Part 180, and you find them by crop. Search the commodity tables of Subpart C (specific tolerances) for the crop's name and for any crop group or subgroup it belongs to. Then check Subpart D for exemptions that need no numerical limit, and the expiration/revocation column to confirm each entry is still in effect.

Approach: I searched the current eCFR text of 40 CFR Part 180 and ran strawberry as a test crop.

How the lookup works, step by step

  1. Search the commodity column for your crop. Each Subpart C section covers one pesticide. "Strawberry" gave more than 50 entries, including:

    • flutriafol at 1.5 ppm (§ 180.629) [1]
    • bifenazate at 1.5 ppm (§ 180.572) [2]
    • indoxacarb at 4 ppm (§ 180.564) [3]
    • pyriproxyfen at 0.30 ppm (§ 180.510) [4]
  2. Search the crop-group names too. Many tolerances are set for a whole group rather than one crop, so they appear under the group's name. Examples:

    • "Berry, low growing, subgroup 13-07G" carries mefentrifluconazole at 2 ppm (§ 180.705) [5]
    • the same subgroup carries cyclaniliprole at 0.4 ppm (§ 180.694) [6]

    A search on the crop name alone will not find these group rows. Confirm your crop is a member of the group before relying on a group tolerance.

  3. Read the qualifiers on each entry. Some entries are limited to a particular use. For example, "Strawberry, postharvest" carries 60.0 ppm for inorganic bromide residues from methyl bromide fumigation (§ 180.123) [7].

  4. Check whether the entry is still in effect. An expiration/revocation date of "None" means the tolerance is still in effect. Examples:

    • carbaryl on strawberry at 4.0 ppm (§ 180.169) [8]
    • napropamide on strawberry at 0.1 ppm (§ 180.328) [9]

    An entry with a date is time-limited or due to be revoked.

  5. Read the residue definition. It says what is measured to check compliance. Under § 180.700, for example, compliance with the afidopyropen tolerances "is to be determined by measuring only afidopyropen". The section header also lists the Federal Register amendments, up to 91 FR 6789 of 13 February 2026 [10].

  6. Check exemptions in Subpart D. Some substances are exempt from the need for a tolerance, so they have no ppm figure for the crop. Search Subpart D by substance name or CAS number.

One gap in this run: our copy has no ppm value for some strawberry entries, such as afidopyropen (§ 180.700), bicyclopyrone (§ 180.682) and cyantraniliprole (§ 180.672). For those, the figure is in the section's table on eCFR.

If you tell me your crop, and the pesticide if you have one in mind, I can list every Part 180 tolerance, group entry and exemption that applies.

Q.02

How do tolerances differ from maximum residue limits?

A tolerance and a maximum residue limit (MRL) are the same kind of thing: a legal cap on how much of a pesticide residue a food may carry. "Tolerance" is the US term under the Federal Food, Drug, and Cosmetic Act. "MRL" is the term used in the EU (Regulation (EC) No 396/2005) and by Codex. The real differences are in how each limit is justified, what happens when no limit exists, and how each system treats the others' limits.

Approach: I read FFDCA section 408 (21 U.S.C. 346a, 2023 U.S. Code edition), the articles of Regulation (EC) No 396/2005 on scope, definitions, decisions and compliance, and records from the Codex pesticide residue database.

PointUS tolerance (21 U.S.C. 346a; 40 CFR Part 180)EU MRL (Reg. 396/2005)Codex MRL (CXL)
Legal effectA residue in or on a food "shall be deemed unsafe" unless a tolerance is in effect and the residue is within it, or an exemption is in effect [11]"the upper legal level of a concentration for a pesticide residue in or on food or feed" [12]Defined in the EU Regulation as "an MRL set by the Codex Alimentarius Commission" [12]. It is binding only where a national system adopts it.
BasisEPA may set a tolerance only if it is "safe": "a reasonable certainty that no harm will result from aggregate exposure", including all dietary and other reliable exposures [11]"based on good agricultural practice and the lowest consumer exposure necessary to protect vulnerable consumers". The critical GAP is the use giving the highest acceptable residue and "is the basis for establishing the MRL" [12]Records carry a JMPR evaluation year and an ADI. For example, quinoxyfen on strawberry is 1 mg/kg, with an ADI of 0-0.2 mg/kg bw (2006) [13]
No specific limit setNo default level. Without a tolerance or exemption, any residue is deemed unsafe [11]A default of 0.01 mg/kg applies, unless a different default is listed in Annex V or the substance is in Annex IV [14]Not applicable
No limit neededAn "exemption from the requirement for a tolerance" (Subpart D of Part 180), held to the same "safe" standard [11]Substances listed in Annex IV ("No MRL Required"). Member States may not block products on residue grounds where the substance is in Annex IV [14]Not applicable
Processed foodA residue in processed food made from a commodity with a tolerance is not unsafe if it is no higher than the commodity tolerance and residues were removed "to the extent possible in good manufacturing practice" [11]The Regulation applies to "fresh, processed and/or composite food or feed" [15]Not applicable
Relationship to CodexEPA "shall determine" whether a Codex level exists. If it does not adopt it, EPA "shall publish for public comment a notice explaining the reasons for departing from the Codex level" [11]A CXL is one factor the Commission must take account of when setting an MRL [16]Not applicable

Where the words overlap, and can mislead

  • "Import tolerance" in the EU is an MRL. It is an MRL set for imported products where the use is not authorised in the EU for reasons other than public health, or where a different level is appropriate for the same kind of reason [12]. It is not a US-style tolerance.
  • Units. Part 180 states tolerances in parts per million (ppm). EU MRLs and Codex limits are stated in mg/kg.
  • Non-threshold effects. Section 408 has a separate route for "eligible pesticide chemical residues" with non-threshold effects. Such a tolerance may stay in effect only if conditions on benefits and risk are met [11].
  • EU derogations. Member States may authorise residues above the MRL after a post-harvest fumigant treatment for the combinations in Annex VII, under controls. In exceptional cases they may also allow non-compliant treated food or feed with a view to setting a temporary MRL [14].

The practical upshot for exporters is that the "no limit set" case differs. A pesticide with no US tolerance and no exemption for a crop makes any residue on that crop unlawful in the US. In the EU, the same gap generally means the 0.01 mg/kg default applies.

If you give me a pesticide and crop, I can compare its Part 180 tolerance, its EU MRL and its Codex CXL directly.

Q.03